This documentation is specific to MS Outlook 2010 configuration on a MS Windows 7 workstation, but similar steps can be followed to configure MS Outlook 2007 and 2013.

(These instructions should only be necessary if AutoDiscover is not setup.)

Note: Not supported with Outlook 2003 or prior.

1. From Control Panel launch the Mail applet.

Exchange 2013 - Manual Configuration For Outlook 2010

2

2. Click Add to create a new Mail Profile. Enter a Profile Name and click OK.

Exchange 2013 - Manual Configuration For Outlook 2010

Exchange 2013 - Manual Configuration For Outlook 2010

3. Choose the “Manually configure…” radio button and click Next.

Exchange 2013 - Manual Configuration For Outlook 2010

4. Choose Microsoft Exchange… radio button and click Next.

Exchange 2013 - Manual Configuration For Outlook 2010

5. Enter snaex15mbx01 for the Server name and the User Name for the mailbox (normally the full e-mail address). Recommended to click the checkbox for Use Cached Exchange Mode. Then choose More Settings.

Exchange 2013 - Manual Configuration For Outlook 2010

6. Select the Connection tab and click the checkbox under Outlook Anywhere forConnect to Microsoft Exchange using HTTP. Then choose Exchange Proxy Settings….

Exchange 2013 - Manual Configuration For Outlook 2010

7. Enter the data as the picture below.

  1. Use this URL to connect to my proxy server for Exchange: ex15.rsapps.com
  2. Connect using SSL only: checked
  3. Only connect to proxy servers that have this principal name in their certificate:msstd:ex15.rsapps.com
  4. On fast networks…: checked
  5. On slow networks…: checked
  6. Proxy Authentication settings: NTLM Authentication
  7. Choose OK, then OK again

Exchange 2013 - Manual Configuration For Outlook 2010

8. Choose Check Name, enter the Password to authenticate the user. (Recommended to click the checkbox for Remember my credentials). Choose OK

Exchange 2013 - Manual Configuration For Outlook 2010

Exchange 2013 - Manual Configuration For Outlook 2010

9. After it has authenticated, choose Next then Finish.

Exchange 2013 - Manual Configuration For Outlook 2010

Exchange 2013 - Manual Configuration For Outlook 2010

10. Choose whether you want MS Outlook to Prompt for a profile to be used or Always use this profile, select the Profile to always use. Then choose OK.

Exchange 2013 - Manual Configuration For Outlook 2010

11. Outlook should now be configured to use your RapidScale Mailbox.